GAS Audio MAX PA1-1500.1DZ1/Z2

DESIGNED FOR MAXIMUM EFFICIENCY
The MAX PA1 Series amplifiers are highly efficient, next-generation Class D full-range amplifiers - perfectly engineered with select, high-quality components and innovative design features that guarantee long-term, maximum output performance.

VCC- OPTIMIZED AIR FLOW
The unique extruded aluminum heatsink with a reinforced A-Star backplate has additional thermal features designed to optimize and control temperature. The GAS VCC (Vented Cross Cooling) system ensures that cool air constantly flows forward over the components and pushes the hot air out through the thermal vents on the opposite side of the cabinet.

HIGH QUALITY & VERSATILITY
The advanced full-range Class D circuitry on a 4-layer PCB allows the connection of any type of speaker - subwoofer, midrange, tweeter or coaxial speaker. The high/band pass filter is adjustable between 15 and 80 Hz, and the low pass filter is adjustable from 50 Hz to 22,000 Hz. There is a bass EQ level control from 0-12 dB for fine-tuning the bass frequencies (35-70 Hz). The PA1-1500.1DZ and PA1-3000.1DZ are available in Z1 (maximum power at 1 Ohm) and Z2 (maximum power at 2 Ohm) versions to suit any setup.

POWER MANAGEMENT AND CONTROL
The powerful, continuous power of the MAX PA1 series is made possible by a stabilized high-voltage power supply that fully monitors voltage fluctuations in the car battery. The amplifiers also feature a 4-way protection circuit system; thermal, short circuit, overload protection and a switch-on delay. The setting of the correct output level is visually indicated thanks to the clip LEDs on the amplifier and the cable remote control - no glow means no clipping, i.e. a clean signal. From a distortion of more than 1 % clipping and anything above this, the extended protection circuit will take effect and, after too long operation in clipping mode, the amplifier will switch to protect mode, which is deactivated again after restarting the power amplifier. This helps to ensure a permanently clean and stable input signal and reduce the risk of a defect. All models also feature high-quality Tiffany RCA connectors.

THE SIZE IS IMPORTANT
The MAX PA1 amplifiers are equipped with two oversized speaker outputs (8 AWG (10 mm²)) and conventional power and ground connections. The PA1-1500.1DZ1/2 has one 2AWG (35 mm²) terminal, the PA1-3000.1DZ1/2 has one 0AWG (50 mm²) terminal and the largest model, PA1-5000.1DZ1, has two 0AWG (50 mm²) terminals.

Operating instructions PA1500.1DZ1 and DZ2
☞(Download)

Data sheet DZ1
☞(Download)

Data sheet DZ2
☞(Download)