MATCH UP 10DSP

Special features

✓ Class GD technology
Audiotec Fischer's unique Class GD concept combines the advantages of Class G technology with the principle of a Class D amplifier.
This results in an unusually high level of efficiency that even surpasses conventional Class D amplifiers. The Class GD concept demonstrates its advantages at low and medium levels by varying the internal supply voltage of the power stages in stages depending on the amplitude of the input signal. This drastically reduces the average power loss generated by the amplifier.

✓ ACO - Advanced 32 Bit CoProcessor
The MATCH UP 10DSP amplifier uses a particularly powerful 32-bit CoProcessor of the latest generation for all internal and external control and communication tasks. In contrast to the previously used 8-bit processor, this results in significant speed advantages not only when switching between different sound setups, but above all in data communication with our DSP PC-Tool software. Another significant advantage is the integrated, native bootloader of the CoProcessor. This enables software upgrades of all components of the DSP, for example to adapt the microcontroller-controlled ADEP.3 circuit to future changes in the diagnostic systems of factory radios or to expand the device with additional interfaces. In addition, thanks to the new flash memory, the ACO offers space for 10 sound setups instead of the usual two.

✓ Intelligent high-level input ADEP.3
Modern, factory-installed car radios are becoming increasingly intelligent with regard to the diagnosis of the connected speakers. The latest generation in particular is equipped with additional monitoring functions so that error messages or even malfunctions can occur if an additional amplifier is connected. The new ADEP.3 circuit (Advanced Diagnostics Error Protection Generation 3) prevents these problems without putting unnecessary strain on the radio's speaker outputs at high levels.

✓ Start-stop capability
The power supply unit in the UP 10DSP amplifier ensures the internal power supply even in the event of short-term dips down to 6 volts. This ensures that the amplifier remains fully functional even when the engine is started. If the on-board voltage drops below 10.5 volts for longer than 5 seconds, the amplifier goes into "Protect Mode" (status LED lights up red continuously) to prevent further discharge of the battery.

✓ Automatic digital signal detection
The UP 10DSP allows signal-controlled switching between the analog and digital inputs. As soon as an audio signal is detected at the optical input, the amplifier switches to this input. This function can be activated in the DSP PC-Tool software or, alternatively, manual control can be selected via an optionally available remote control.

✓ Power save mode
The power save mode allows the power consumption of the UP 10DSP (and any additional connected amplifiers) to be drastically reduced if no input signal is present for longer than 60 seconds. As soon as the "Power Save Mode" is active, the internal amplifier stages of the UP 10DSP and the remote output are switched off, thus significantly reducing the power consumption. The amplifier returns to normal operating mode within 2 seconds as soon as a music signal is applied to its input. The switch-off delay can be varied or completely deactivated using the DSP PC-Tool software.

Note: The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Audiotec Fischer GmbH is under license. Other trademarks and trade names are those of their respective owners.